The clean steam generator is use to avoid chemicals normally use in steam water treatment, in steam injection process such as humidification and sterilization. It is basically a shell and tubes steam to steam heat exchanger design to use higher steam pressure from the steam boiler and generate lower clean steam pressure for the process.
Learn More
Steam generators are very rapid acting (produce steam within seconds). Superheated steam often leads to a reduction in the number of boilers, a reduction in the feed water usage, reduction in boiler load, improvement in the process timing, a reduction in the reagents, and …
Learn More
If the plant has only one steam generator (boiler), uses a single fuel, and has a single steam pressure level, it is relatively easy to assign a cost to the steam. However, in most cases, there are multiple steam sources and multiple fuels. There are also multiple
Learn More
Steam generators are very rapid acting (produce steam within seconds). Superheated steam often leads to a reduction in the number of boilers, a reduction in the feed water usage, reduction in boiler load, improvement in the process timing, a reduction in the reagents, and …
Learn More
Trevithick was the first to successfully use high-pressure steam (then known as "strong" steam). Until ca. 1800, the weakness of existing boilers coupled with the influence of James Watt had generally restricted steam boilers to very low pressures or "weak" steam.
Learn More
The steam is expanded in the first stage of the turbine until it is dry at (30 bar), then it is reheated to (350 Co). (8%) of steam is extracted from the first stage of the turbine to heat the boiler feed water. Calculate the fuel mass flow rate, if the high heat value of the fuel is (31 Mj/kg). 9‐ During a steam generator performance test
Learn More